Finally found a tall enough gun bag for my .25 Bobcat MKII

[Cayin]

While im waiting for spring, ive been looking for more stuff to buy:
Its the UTG PVC-MC42B, just tall enough for my Bobcat with the following setup:

- MNT-DNT06 UTG dovetail to picatinny drooper rail.
- RGWM-30L4 UTG low picatinny 30mm rings.
- 13 310 Hawke Airmax 30 SF 4-16x50.

"Im sure this one is tall enough", yeah, i said that a few times before i got this one.
Now all i need is some nice warm weather to get the scope re-adjusted after changing from medium to low rings.

 

[TonyT]

I assume it is 42 inches long. What is the height?

 

[ClearedHot]

It's supposed to be 14" high. I have one on order. Well reviewed. It should just fit my scoped MK1 Bobcat with maybe an inch to spare. 

 

[Cayin]

The problem with these bags is that the dimensions are fine if you have a paper thin rifle, but you lose a lot of height when you put an actual rifle in it.
The "fatter" the rifle, the more height you lose.

 

[GBGUNNER]

When I searched for a bag after returning one. I traced the outline of my bobcat onto cardboard folded it 4 times and kept unfolding it to ckeck after I used a tape measure to estimate if a bag had potential and per Cayin I made sure I had room enough for the widths of the gun. It's too long a drive to make the mistake again.