Search results for query: *

I never saw this magazine but as I have mentioned above, I am thinking of modifying the magazine on the same lines.

The user is shooting 23 grain .218 slugs. May be if he uses longer slugs, his issue be resolved.

Try one thing please. Keep the magazine upside down and then push the slug upwards with allenkey. When I did it holding the magazine in my hands, two slugs dropped down as I pulled down the allenkey. There may be some factor of length of slug or dia involved. When complete magazine filled...

If nothing else worked, I am thinking of making a round cut on the edges of the centre part that rotates. The cut would be of such clearance that it could hold an O ring of 2mm. I hope that the O ring will hold the slugs.

There must be something wrong with me :rolleyes:. Again advised a user to buy VULCAN 3 in .22 with unchoked 700mm barrel for shooting slugs. The gun came and we tested it. It's as accurate with .218 slugs as it can be. But another issue popped up. When the user pull the cocking lever back...

Blank

The competition shooter needs to adjust the fps even during a competition considering wind conditions. So he needs quick adjustments. Very fine adjustments anytime without using any tools.

Sportsmatch ATP61

Following is the video explaining the micrometer based anti hammer bounce device installed in RAW HM1000X and some chrony work.

In fact I was not expecting this much efficiency. I am amazed too.

Following is the video showing the results of 90cc inline plenum, peek valve and anti hammer bounce device using 18.13 grain JSB .22 pellets at around 940 fps. The regulator is pre set from factory at around 146 bars. 220 dry shots are taken and then theoretically converted into projectile...

Someone needs it for more refined and repeatable adjustments of hammer spring.

Every user is different and has different requirements. I personally use a 33cc hanging plenum and there are threads at its bottom to install regulator gauge if needed. Otherwise a screw keeps that threaded hole sealed.

No

More pics here

I am not going to use it. Someone asked me to make it for him. I thought let's see how it goes.

Will you please share the barrel modes you have done for the knowledge of every member here.

Finally got the micro adjuster of hammer spring of RAW HM1000X. I shall test it as I find a time slot. Pics are hereunder,