Search results for query: *

Did you ever get an order of pellets and find the tins wrapped and wrapped and wrapped again in tape? You end up spending quite a bit of time trying to remove all the tape and it tares the labels off and leaves sticky stuff all over the tins. Then you need to tape the labels back on. Not...

I'm looking for advice on getting the end cap off for a liner change on an Impact barrel. I've tried a rubber strap wrench, heat and a few other techniques. It's a shame they didn't cut a couple flat spots for a wrench here. Any ideas on loosening this without damaging it?

Like new in box. Kraford & Lypt FX Impact Gen 3 Trigger Guard with Arca and Picatinny Rails. Has both Arca and Picatinny Rail systems and has T-track for further customization and options.As new in box. Perfect condition with one dust size imperfection inside trap door for foster air fill...

When tuning for a specific velocity, does the shot count increase with lower reg pressure and increased hammer spring pressure?

I am adding another caliber to my Impact X and I have a question about how things line up back there on the rear block. When the barrel goes all the way in with the notch lined up, the end of barrel goes too far into the magazine area blocking smooth operation of the magazine in or out. I have...

Looking for any advice on installing a Power Plenum, Any gotchas, tips, wisdom. The kit is on it's way. Chicken out now and don't do it, is welcome wisdom too. The Airbuks video is the best one I can find. Any recommends appreciated.

I'm looking for a source or a spec for the probe screw and the barrel screw on the Impact. Especially the little probe screw, It's just a matter of time.

I have an ATN 4k Pro on my Impact and would like to be able to quick change this scope to other guns. ATN offers one and I'm curious if anyone has already been down this road with this or other mounting options.

I'm interested in a decent gun vice and looking for advice. It would mostly be used with an Impact X. Earnest Rowe has one that looks really good, but it's not available at Midway, Brownell's etc. I saw another, Tipton Ultra, something that would be usable for maintenance as well as shooting...

There are some very elaborate ways to do this. I went with the quick and dirty. The door insert is made from a dump picked screen door. It was sawed in half and sheet metal screws connected the overlapped halves. Three layers of bubble wrap are duct taped in the center and a piece of corrugated...

After some time away, I'm getting back into shooting and picked up an Impact X 700 25 with an Aztec FFP. As delivered the settings looked different than other guns I'd seen. My range is only 120 feet and the gun is obviously way better than me, but initially I'm thinking that it could be...

My CF tank is timed out and I have a compressor. The tank is in great shape externally. Is the limited time life due to some deterioration?