Search results for query: *

I've been casting some 36 gr .217 .218 size I've got them running in the 970s I haven't had a chance to shoot for accuracy yet

If it bent the hole isn't deep enough I've got a Pantera and a DRS which are the sam e valves they are turned down to .090 in that area to help the valve breath better running a tungsten weight from a impact about 14 grams in the 30 cal panther 54 gr slug at 1040 fps in it . I need to shoot it...

Usually it will be leaking too stock hammer weight is like 12 grams where did he find a 20 gram weight it says was used in the first post

It's to bad the shoe box died I'd still have it for a back up

Otherwise it coltri Bauer alkin take your pick

Shoe box will live indefinitely as long as the o rings are what is wearing which with proper grease ur good U might be able to find parts for them otherwise it's altaros booster is only booster I can think of

I try to keep my barrels to 24 inches plus the mod . I wish it were the other way around otherwise it's a broomstick lol

Get more power and efficiency from the dynamic

In my opinion length does better and a short fat moderater

Options on heli board are almost endless once you figure it out 😜 I believe the voltage is how hard the hammer hits and the s- value is like the duration is the way I think of it so as air pressure goes down voltage down and more s value or am I thinking wrong?

On my heliboard I went up to p7 or p8 which is about the speed 930-950 for 25 gr 22 cal if you have the hp

If it tripped your house breaker probably the motor

I like to push it to the limits and then back off the adjustments a tad for better life of it and still out perform stock form if the speed works with accuracy otherwise I back it off farther just depends on the accuracy node

That's a dynamic but it is same valve so it should work wouldn't get a lot of shots at that power level.

I've done the same to a dynamic and used a impact tungsten hammer on it and it pushing 30 cal 54 gr slugs at 1040 ish faster if wanted but it's not needed it is definitely easier on the drs to change out a hammer weight tungsten hammer is about 2 grams heavier than the stock hammer

If you shut it off drain it and start it again it goes up to 250 again and stops or is the motor getting hot shutting off and restarting which could be a motor or overheat protector if it has one

Bad barrel can happen in any brand so I wouldn't let it stop me from getting another

I've been waiting for accuracy to drop off but I shoot mainly pellets haven't had a problem yet

Yes it is otherwise I probably would still own it for a spare Mainly I filled a 90 cu in with it which was about a hour to top off

I used to run a bostich pancake compressor set at 110 psi going to a shoe box booster and one water trap for 10 hours at crack and purge tank once in awhile to get rid of moisture and a small cotton trap otherwise I never had trouble with water it gets pretty humid here in the Midwest next to...