Search results for query: *

1669.50

500.01

I need it. Is it still available? =Danny

I would like to purchase this item. Which address do i send the paypal gift to? =Danny

599.99

I understand your reservations about drilling into your Wildcat's stock. There were a few people that broke ground in this respect when Wildcat owners began to install picatinny rails for the bipod mounts. My wish to install the Magpul quick disconnect sling and Atlas bipod motivated me to...

To answer your question Dartagnon, the air breather hole cam from the factory very rough. I used a jewelers rat tail file to smooth it out as best I could. Not sure if AoA gave it a once-over when they had it in for service? =D

I am going to have to eat crow, the Wildcat is most definitely holding air after AoA service. The inital drop in air pressure must have been due to some settling of the seals after repressurizing gun post reassembly. Feeling a bit sheepish but very happy that the Wildcat holds air.

Followup: Well, it's been about 8 months since I made this post. I was very reluctant to send my air gun in for service so soon after receiving it so I did the following. Following Johan's instructions I removed the air regulator and re-seated it with no success. The air rifle continued to...

One other thing to pay close attention to is if you are canting the rifle or not. The scope rail on these Wildcats sit high and depending on the scope and rings you choose it will sit even higher. Investing in a cant level is a must with these, in my opinion.

FX Wildcat .25 JSB King Heavies MKI Fill to 240 Bar 7 Mags/56 Shots Last Manometer reading @ 130 Bar Note: All Bar readings from manometer on rifle. ​​​ Date: 11/7/2015 Time: 6:56:10 PM Grains: 33.95 Hi Vel: 822 Low Vel: 800 Ave Vel: 810 Ext Spread: ...

You should try medium scope rings. This will bring the scope reticle a little closer to where it needs to be without maxing out the vertical limit.

Thank you 30cal, the monopod when fully deployed extends from 2.7" to 3.7". You can also leave the unit "unlocked" and wrap your non-trigger hand around it and variably adjust the height by pivoting the unit manually. 

An BT authorized dealer on ebay, Rock Hill Sports, for $85.

I have installed the Accu-Shot BT04 Monopod to the Wildcat. The groups have tightened up by about a 1/4" at 50yds from using a sandbag in the rear. I think it looks pretty tight, what do you think? I went with the sling stud mount option using an Uncle Mike's sling stud kit...

FX Wildcat .25 shot strings. 70°F 56% Humidity 992 Hpa/29.29Hg Elevation 157 ft. I shot a 7 mag string (56 shots) of 25.39 grn JSB EXACT KING .25: from 250 Bar down to 140 Bar: String:1 Date:11/6/2015 Time:6:29:18 PM Grains:25.39 Hi Vel:912 Low Vel:890 Ave Vel:900 Ext Spread:22 Std Dev:3...

The Wildcat in .25 cal is doing it for me lately. My wife even says it's sexy.​

No problem whatsoever rockymtbiker, I use an Hawke Sidewinder 8-32 x 56 scope and the eye relief is 3.5". Where I have it mounted is perfect for my cheek weld.

Yeah rockymtbiker, there is a slight bias towards the front of the rifle, but not too much. The balance point of this wildcat is at the trigger w/o bipod. =Danny note: There are also two other Quick Detach points on the rifle, one at the rear of the stock and one right behind the atlas rail...

I did it with my fx wildcat and it works pretty good.