I had an older model Airgun Capital moderator that I had for a while sitting in my safe. I tried it on my FX DRS and it blew the end right off it. A quick e-mail to Airgun Capital, just to let them know it had failed, resulted in an offer to replace it with their new model.
The new moderator arrived a couple days ago, and I really like the new design. The old one was3D printed, the new one is all aluminum. I was originally thinking of using it on my DRS, but it’s a tad too small in the overall diameter, so it looked odd, but the diameter is perfect for my Crown! I replaced the Huma-Air MOD30 I had on the Crown with the new Airgun Capital moderator and it’s now stacking pellets hole in hole! It’s a tad louder than the Huma-Air suppressor, but I’ll take the tighter groups over a decibel or two!
Below is a picture of a 3 shot group. These are JTS 18.1 grain pellets shot at 35 yards.
Over all I'm very happy with the new moderator and very impressed with Airgun Capital's Customer Service!
The new moderator arrived a couple days ago, and I really like the new design. The old one was3D printed, the new one is all aluminum. I was originally thinking of using it on my DRS, but it’s a tad too small in the overall diameter, so it looked odd, but the diameter is perfect for my Crown! I replaced the Huma-Air MOD30 I had on the Crown with the new Airgun Capital moderator and it’s now stacking pellets hole in hole! It’s a tad louder than the Huma-Air suppressor, but I’ll take the tighter groups over a decibel or two!
Below is a picture of a 3 shot group. These are JTS 18.1 grain pellets shot at 35 yards.
Over all I'm very happy with the new moderator and very impressed with Airgun Capital's Customer Service!
