Recent content by Steelontarget

I heard of Vibra-Tite on GTA. The blue loc-tite was not doing the job on my springers. I read that Vibra-Tite did a better job of holding on the springers but you could still loosen the screws. By golly! It worked! I use it on some of my powder burners as well. DO NOT GET ANYTHING OTHER...

That's been so long ago that I cannot remember if I installed an o-ring or not. Either way, there is an o-ring there now. I also put vibra-tite on the threads and haven't had a problem since then.

If anyone is like me, they like the KYL targets. So I thought about combining the hostage target shooting game with KYL. The attachment has the target, the rules and a score sheet with pre-printed values to help make scoring and calculations easier. Any suggestions or feedback is greatly...

The pistol with the arrow barrel looks like something that Q would have invented. Nice collection!

Where did you get the barrel?

It’s just like aiming for an eye on a fly with an accurately scoped rifle. Try it sometime. Smear some honey or syrup on a blank piece of paper affixed to a target frame at about 20-30 yards. When the fly lands on the bait, take it out by aiming at an eye with an accurate air gun with a good...

Are you using a slug barrel? If so, where did you get it?

I have three AirForce airguns. Recommend the CondorSS in .25 caliber. The .22 caliber CondorSS is overpowered, even with the power wheel turned down. I have the TalonSS in .22 caliber and it's perfect for what I need. I have the TalonP and have only had to replace the air pressure gauge after...

What pellet were you shooting?

I made this set-up for use with rimfire rifles and pistols but it will also work with airguns. I have a metal target base that holds a couple of furring strips on each side. I took a furring strip cut to length for the horizontal cross piece. Then I cut slots part way through the furring...

When you see your work posted on another forum it's the greatest compliment you can receive! I made that target up some time ago on GTA. Thank you for using it! I'm open to other ideas for fun targets!

Have you thought about putting a small amount of tannerite inside the vehicles?

That's a good idea and I considered that was well but did not want to void the warranty. Besides, I'm one of the rare individuals that likes the idea of an automatic safety but that's a whole other discussion.

I tried that, as you suggested. However, I am not able to do it. Maybe I'm missing something but the safety cannot be disengaged with the bolt forward on my AirForce guns.