Recent content by Solo1

Seems to me that anyone that is shooting 75 -100 yds with a 22 cal is using 25 gr or heavier

I shoot a ghost

Here’s the target i got them off amazon. Its a 2” outer circle.

Yea 22 going from min to max

Just did some testing on a ghost which runs similar to the black wolf in tuning and for 20 gr and less you want a white spring and around 110-120 bar to have a lot of adjustability Blue for 20 gr and above and around 130 bar remember this is just close to the same don’t take it for exact and its...

You mean for the black wolf ? Im shooting a ghost. They are close to the same in tuning and velocity’s. And yes if you could restrict port size a little that would be another tuning option.

Just did some testing on a ghost which runs similar to the black wolf in tuning and for 20 gr and less you want a white spring and around 110-120 bar to have a lot of adjustability Blue for 20 gr and above and around 130 bar remember this is just close to the same don’t take it for exact.

For jsb 0 fps lol i find from 880-970 works but jsb has too many flyers seems jts and aea are better choices than jsb

For me i have absolutely no interest in an electronic gun. I’ve had 2 redwolves and will never have another. I now have 3 ghosts and love them. I haven’t shot the 22 much but found a tune for 25 gr that shot very well but am trying to find a tune now to see if i can help others to go from 18-25...

Couldn’t understand why the blue spring didn’t work so i tried 1 in the ghost and found little difference at 130 bar than the red had over 100 fps adjustment on 25&18 gr but the 18 only went down to 960 fps.

Oh well seems the ports are just too large on the blackwolf and you have to really go to the extreme to use less than max power. Not only is it expensive they made it so its not as tunable as the ghost.

Did you drop reg to 100 when you tried the spring? I just set up 1 of my ghosts in 22 its at 130 bar pw 15 red spring 23” barrel 960 fps for 25.3 gr pw on min 880fps. 1023 with 18 gr on min i would have to go blue spring to get the 18 velocity down

Have you shot it with the blue spring and what are your results ?

I use wheel brg grease just a dab on your fingerenough to just be seen film on parts

Doubt you will find torque specs anywhere but its best to try not to over tighten especially the barrel screws as you can actually push a dent in the barrel! I just put a light film of grease on the pivot bush and where it slides