Recent content by Rimshot

Thanks very helpful

Ok once one has the near and far shot numbers what is the next step? A formula of some sort?

Thanks for the information. Something else that puzzles me depending on whos system you chose is that the more tension you apply the more your pulling on one set screw or am I missing something here. Well maybe theres another system just around the corner.

I am thinking about purchasing a barrel tensioning system for my Impact M3 sniper .30 . I read about the FX system increases the muzzle crack. My question is does the Huma-air or the Bullet central systems do the same thing?

Have you checked that the sensor is seated on the circuit board.

I was able to use my sent up over the weekend. Three different shooting sessions over three days.. My FX Boss, Impact .30 cal M3 sniper, and .22 Marauder. Over 4 hours of total run time and more than 250 rounds and not one missed shot. I did have one shot register that I didnt shoot that was...

Ok I installed the voltage converter and heres what I found. With the 18650 battery at 3.9 volts the current draw without the converter was .085 ma. With the converter in the circuit the output voltage increased to 5 volts and the current draw increased to .230 ma. The current draw was basically...

oaks1450 glad you liked it. DaystateRebel Interesting I can see how that might work. By using that module you will be running the battery down below the threshold that the chrony will operate at but the module will still be putting out 5 volts. I am curious what the trade off is. You could...

Yep there are alot of fake mah. ratings out there. I would say anything rated over 3000 mah and weight less than 40 grams is probably a fake rating. I have seen them rated as high 11000 mah. which is impossible. I had these batteries and sockets leftover from other AAA 3 battery conversions.

Thanks fe7565 That answers my question on whether or not the current changes. So it looks like one battery will suit my needs just fine. 

I decided to buy the FX chrony because tuning my Mrod and Impact M3 I felt I was just wasting lead shooting through my F1 chrony.. With the FX chrony I installed it on a CF tube and mounted it to the side rail on my M3. I have a teryx stock on my Mrod so I can use the rail on the bottom. This...

91.59

I like it. I will take one if you decide to manufacture some as I have no access to a 3D printer. Rim

I set you a email weeks ago asking for a new oring the one that came with my gauge looked used. I sent you a PM here still have heard nothing.

1616