Recent content by Rich7777

That's a great point. I believe it should fit any of the hatstan models. PM sent

Hey yaya, I don't think I'm allowed to answer this in the open forum, as we're not an official advertiser with AGN yet. PM sent. -Rich

So 2 cool things have happened lately. Bigragu let me know about a cool fill port plug for the Bully. We were discussing how to plug the fill port hole on the Bully if we removed the mechanical slide that covers that hole. He found someone on eBay that makes a fill port plug. I ordered one and...

On my .25 cal Bully, I ended up backing the Hammer Spring Tension (HST) screw out almost 1/2". I don't know about the power impacts by measuring turns. To set the power where I wanted it, I set my pressure to 3000 psi (just a little above 1/2 the shot pressure range) and started shooting and...

lmold That is one good looking setup! I can't believe you're making me go buy that tethered regulator rig ... that's the story I'm telling the wife and I'm sticking to it. It's all your fault. :) -Rich

To follow up on this, Dennis said none of the Bullys coming through indianaairguns.com has this transfer port restriction knob. The more I look at that video, the more I'm convinced this is an aftermarket mod. They use a silver colored hex bolt on the knob. The factory Bully has a higher...

Hey PelletPusher, Measured my shroud OD, it was 26mm / 1.02"

Glad to hear you're happy with the Hatsan Bully. Sorry to hear about the magazine burs. Hopefully a small file or dremel will make quick work of getting rid of them. Great catch, BTW!

lmold, glad you were able to get it where you want it. I'm the same way, I like / have mine set to 2 lbs 6oz. 

A friend just bought a .30 cal Bully and asked if I would adjust his trigger to a light 1lb second stage. After playing with it for a bit, I've got a decent travel on the 1st stage coming up to a clean stop on the 2nd stage. The second stage break is averaging 1lb on a Lyman trigger gauge. There...

First and Second stages are adjustable It's heavy out of the box, no doubt. I adjusted mine down to 2lb 7oz. Much better. Remove the stock and you'll have quick access to the adjustment screws. Directions with the gun describes the details. -Rich

I'll ask Dennis at IndianaAirguns.com to see if he can find out if Hatsan made a change. I'm doubtful, but anything is possible.

I'm looking at the Altaros, but I can't seem to get them to send me an invoice. *Sigh* It's either them or lane. I don't think Huma released their external reg yet.

The Bully in the video has been modified. That dial isn't factory. Judging by the location, I would say that's a transfer port restriction.

I'm ordering an Altaros reg for my 25 cal. I believe the regs max out at 150bar. I emailed them asking if they would offer a higher 150 to 200bar range and got no response. I'm going to order it anyway. I'm hoping it's controlled through a bellevile washer stack that I can "adjust" :) The...