Recent content by Raydee38

I had the exact same problem with my .25 RAW with the same JSB pellets, just could never get it to group as good as I thought it should. I switched to a .22 caliber since I am only shooting at 50 yards max and the groups are much better. I bought a bunch of different pellets to try out and...

Thanks for the idea's guys, I fired up the cad program and had some time to 3D print this mount. I just have to get some shorter thumb screws at the local hardware store and I will be good to go.

I would agree but turning the hammer spring down should at least lower the fps?

I use a test gauge from Huma that threads into the blanking plug on the bottom of the action.

How old is it, my Huma reg is extremely consistent but it’s fairly new so time will tell if it holds up.

The Huma reg is a bit smaller and allows for a slight plenum increase which is why you are seeing an increase in FPS. I had to turn my Huma down to 110bar to get my .22 18gr pellets to shoot around 920-930fps.

I have my reg turned way down (Huma Reg), I had it set to 140 or 150 and was shooting .22 pellets at 1010fps so I turned the reg down to 110bar to get the pellets shooting closer to 920-930 with the hammer spring about right in the middle of the travel. Backing it all the way out makes just...

Here is the part I am not understanding with my RAW .22, even if I am maxed out with the reg set at say 120bar and shooting 930fps with the hammer spring all the way in, shouldn't it still slow the FPS down when it is screwed all the way out?

I will def look into that. I wonder if the RAW .25 comes with a heavier spring than the .22 does. I did switch the barrel and probe on my RAW .25 for a .22 but never messed with the hammer spring.

I swapped out the RAW reg on my .22 with a Huma regulator and to get the desired velocity I wanted I had to turn the Huma reg down quite a bit (110psi). After that my hammer spring barely makes any changes also.

Is there any way to make the screen stay on longer with the 25mm V2 gauge?

I just bought a few tins to try out after struggling with random JSB flyers that were making me crazy. Hopefully the wind calms one of these days so I can try them out.

very good for the money

Has anyone tried the JTS wad cutters? Wondering if they will be accurate at 50 yards like the domed version?

Yes, at first they said that there were no parts available but then ended up sending me the parts.