Recent content by NavyKayakGuy

104.10

539.74

There was some dirt or something on the valve stem. Cleaned it out. Good to go. Thanks everyone

So I had some issues when I first got my rifle about a week ago. Thought I fixed the issue. Replaced all lrg o-rinds. Yesterday I chrony'd the gun. Shot about 40 rnds through it. Left 1500 psi in it. Put the gun away. Pulled it out this morning, gun is at 0. Put 1000 psi in and could hear air...

Took her apart, replaced the 4 large orings with stuff I got from HD. Had some silicone grease my hill pump came so I used that. Tightened everything up. Even telflon taped some threads. Charged to 2kpsi and went out for a few hours. Came back and still at 2000. Looks like shes a keeper. Thanks...

Thanks for the advice everyone. I watched some youtube vids on disassembly and seal replacement. Looks pretty easy. No specialized tools. Can I use o-rings from home improvement or automotive stores or do I need mrod specific o-rings? I have lube that came with my hill pump. Can I use that or is...

Also considering just return for refund and get an AT44 .25. I wasn't planning on doing any mods. The mrod is .25. Found an AT44 for $449. Just $50 more than the mrod. What do you guys think?

Hi everyone. I'm new to PCP rifles and got my new mrod in a few days ago. Finally got around to charging it. Knowing the leak issues with these guns, I charged it and let it sit for a few hours. Came back to find the gauge reading 1500ish psi. Tried to exchange for another, but seller (Midway)...

Juan here from Visalia.