Recent content by MddogHutty

Hi Jim yes I have just ordered a pin spanner has I tried making one and 1 off the pins snapped it was worth the try. The thing is I have never rebuilt a regulator before and could do with some instruction to do so along with how to tune the reg once I have rebuilf the reg. Here is an image of...

Hi guys I'm after some advice on removing the reg on this rifle I have tried needle nose pliers and cannot get it unscrewed so any advice on how to remove this would be great. Also I'm removing it has the shot curves gone all over the place has it was extremely consistent so any thoughts on how...

Hi guys I would like to know if anyone else has tuned the SMK Artemis M16 Alpha rifle has I had too change the pressure guage and seals and must of knocked the reg settings out. So now the the shot string is pretty bad so if anyone has tuned the M16 Allha really could do with some advice on hot...

Hi all just thought I would ask if anyone has come across this problem before on there rifle. When filling my rifle on the compressor said filled too 300bar but on the gauge was only reading 100bar. I know it will probably be a gauge issue that either the small seal isn't sealing properly but...

Here are the pics of my setup with valve release at the end i do have 2 airmegas but took one off

I'll take some pics in the morning has I added an extra gauge with release valve after my large filter setup. But I have ordered the male too male Foster fitting to connect the hose from compressor too bottle. I could also do with someone telling me the safest procedure to fill and disconnect...

Thanks for your comments guys So all I need is the male to male fitting and I can go ahead and fill the tank and yes I have a bleed valve on the tank and also on the line so I have the ability to double bleed on hose and the tank. Just also wanted to know do I build pressure in the line before...

1362 - great prize thanks too Steve and micheal and all the sponsors good luck to all.

Hi guys I'm trying to find out if I need any other connectors to refill my dive cylinder from my compressor. Or if I already have what I need to do this process with the setup I have can I just connect the air lines, also the steps I need to follow when starting from the compressor too fill...

Yes thats the one slayer just need too get a link too the correct lens has the ones I have found have been light too dark. So if you know of any could you please share link to them thanks.

I know its a 2 way mirror but I've only found the light to dark ones im after the one which I clear on both sides. So if anyone knows where I could possibly get the ones im after could you please pass along the link thanks 

Or is it just a normal cut mirror at a 90° angle 

Hi all im trying to find out the see through glass mirror used in the sideshot. Has im doing my own project on my 3d printer and don't really want to have to use the bulky 90° prisims. So if anyone can help please reply to this thread thanks.

1360 - and I think Steve is right more giveaways would be extremely beneficial to newbies and for seasoned pros so thanks.

Yes guys thanks for all your comments i just thought you would be able to convert my plugged yong heng so it would be able to run off a car battery. So with all your comments and suggestions. I may has well keep that one for home and spend the extra and buy a tuxing for when out and about which...