John1966's latest activity
John1966 reacted to thammer's post in the thread Kral Puncher / breaker, Airtube material and Valve with
Like. No issues at all with the new Kral guns. Valves and levers have been sorted. Tube is steel on the PB, Pro and Mega but aluminum on the...- Today tested my Pallas Hamburg Maxi Synthetic 5.5 Fac. I've had it completely taken apart, everything cleaned and polished All the...
- John1966 replied to the thread Kral Puncher / breaker, Airtube material and Valve.I just got a pallas Hamburg Maxi Synthetic 5.5 Fac, has it the better Valve valve in it? Anyway i did my first test from 20 meters...
- Hi everyone!! 🤗 I'm new here and would like to put up a discussion on DIY airguns built with some AliExpress parts. For now, I don't own...
- John1966 replied to the thread Huma regulator service interval?.This is what I was told by Huma air when I had ordered one for my P35 6.35 but had forgotten what it was for when I ordered one for my...
- @John1966 I would listen to @nervoustrig. I was assuming what that screw was for. I’m more than confident that he knows. He’s helped me...
- John1966 replied to the thread Huma regulator service interval?.Is this also the reason that when I shoot that I hear the air pass through the regulator?
- @John1966 What I’m saying is that the installation of that screw should not stop you from turning the reg adjuster. However, my thought...
- The small grub screw (M3) in the brass adjuster acts as a flow restrictor. During the refill cycle, the air from the reservoir must...
- John1966 replied to the thread Huma regulator service interval?.Oké thanks very much mine is set at 150 bar and put the little screw in
- John1966 replied to the thread Huma regulator service interval?.What's the tiny screw for at the top of the Huma regulator, i mean the very tiny screw that's goes into the screw where you set your...
- John1966 reacted to dj0000ro's post in the thread $335 for a 9mm SPA/Artemis/Snowpeak M25 with Like. Did anyone tried to do the bootle swap?
