Gear_Junkie's latest activity

What gauge/thread size did you use, and how did you get it to seal to the block?

Wow, homemade - VERY NICE!!!

Thank you! It's made from a walnut tree that was growing on top of my father in law's septic tank. It's loosely copied from my own...

Once again, nice work!

Following are pics of the gun in which initially an external plenum of 33cc was installed. Later made an arrangement for a regulator...

I've tried a couple different Donny FL moderators, an Impulse Air IA-1200, as well as 2 of my own design. I found the IA to be...

Hi all, I set up this little hw50 as a lightweight shooter for WFTF Field target for my dad. I was going through some pellet testing...

Very cool, thanks for posting this! Gorgeous stock BTW.

Yes, sorry, it's an HM1000x with the 480cc bottle. And thanks for the confirmation on efficiency. I guess I'm just surprised at how...

For efficiency you need anti hammer bounce device. Bhaur

I might need to have another SSG made. I tried my current one, but all of my heavy hammer springs have too small an ID to fit over the...

Not unless your experiencing hammer bounce and the lighter hammer helps eliminate/reduce it. Increasing reg pressure and going further...

Thanks for the explanation Matt! The rifle is super consistent, shooting at 939fps +/- 3fps, and comes very smoothly off the reg...

I have an ultra picky .22cal LW Poly barrel in my RAW. The only pellet/speed combo I've found to work is shooting JSB RDM Deep Pellets...

I like this one....