DanT55's latest activity
DanT55 replied to the thread Inside the Skout Epoch.In my .25 I made the mistake of going higher on the LP (130 to 160) in relation to the HP (1400 to 1500) and could not get the results I...- DanT55 replied to the thread Skout .25 Skout Epoch.Could be the poppet seal inside the reg as mentioned above on MFE 105. You can pull out MFE107 then pressurize and if still leaking its...
- DanT55 reacted to PasadenaMike's post in the thread FX Anyone ever get the urge to eviscerate a fly but by the air from your PCP only…? Just me? with
Like. My Bug A Salt has had more kills than any of my Airguns. It’s not a pcp but rather a single stroke pneumatic - DanT55 replied to the thread .30 Skout @100Y.Looks like they still have them on..they are really air strippers due to the internall design. They do mitigate the report but not as...
- DanT55 replied to the thread Skout Sniper Slug - Official Release.The settings are programmed into the EPOCH screen and can be adjusted from 10-50 in increments of 1 in program mode. The valve and...
- DanT55 replied to the thread Skout Sniper Slug - Official Release.The LPR is what opens the valve under pressure from the HPR. Since its a balanced type valve it doesnt take much to pop it. The Dwell is...
- DanT55 replied to the thread Skout Sniper Slug - Official Release.I was shooting into my rubber filled back stop and using an FX Compact chrono hanging off the moderator. I used the factory BC mentioned...
- DanT55 replied to the thread Skout Sniper Slug - Official Release.Ok, got my .25 slug barrel installed. Set the regs to the recommended pressures HP 1750 (120 bar) LP 190-200. Seems to like 200 better...
- DanT55 replied to the thread Skout .25 Skout Epoch.Got the Epoch .25 slug barrel kit in today. It is significantly beefier than the standard set up and pretty much fills up the carbon...
- DanT55 replied to the thread Skout Skout Epoch Share and Discussion.Excellent mags (.25) but the real value is if you get the sorter and loader combo. You can have 100 rounds ready to drop in during your...
- DanT55 replied to the thread Skout Skout Epoch Share and Discussion.I should be receiving my EPOCH slug liner barrel today along with a tin of matched Corbin slugs. I stuck with the standard barrel as I...
- DanT55 replied to the thread Skout .25 Skout Epoch.Nice work!(y) Looks like that is on the Mac valve assembly. Once confirmed I would depressurize by firing off the solenoid so the LP...
- DanT55 replied to the thread Skout .25 Skout Epoch.It's actually easy to take apart and they have made some incremental improvements since launch. The regs come right out after degass...
- DanT55 replied to the thread Skout .25 Skout Epoch.A call to Skout is a good idea but in the meantime try this or call Skout if unsure. On your HP reg remove MFE107 and the whole bottom...
- I believe the most important factor that's being overlooked is that Skout has a high BC slug and slug barrels that will be tested at 100...