Recent content by carpp

well it seems i cant get hold of the proper valve seat, after phoning the importer they told me there is no other valve seat available apart from the 1 for the boss so they sent me that and its no where near going to fit, anyone have any sources for the hp valve seat?

thanks weatherby i ordered the fx 7019 valve stem complete hopefully that will do it

yes i looked at that, im in the uk and the importers believe there is no such thing as a hammer weight so i will have to look at the european websites to see if i can find one.

yes it came unregged, I've checked transfer port and barrel alignment also put tissue on breech and no leak, I've turned reg up and there's little to no difference, do you have a link to the hammer weight for the boss?

Just put a huma reg in my royale 500, before this it was shooting jsb heavy kings at 730fps, put the reg in set at 140bar from huma and it shot around 750fps now i adjusted reg to 150bar and its still the same to me it almost feels restricted but i dont know where, a quick google search shows...

Only had time for 2 targets today and the slow motion camera wouldnt hold a charge, these we shot with no shroud/airstripper/crown protector and single loaded by hand first target is 50 yards then second is 75 8 shot groups, had two flyers at 75 that i circled other than that i think it looks ok. 

A 5 shot group at 50yards that is covered by a 2pence coin is what would consider ok and thats what the gun will do, probably better if i put more range time in, over the next few days i will get some targets of 50/75/100 with a bare barrel and hand loaded as suggested and post the results...

Some of these are a bit blurry the camera doesnt focus very well

Yes i am from the uk but it is an FAC rifle 50 ftlbs so i would of thought it would be the same spec as the stuff the US gets?

John the mark on the pellet is a bit of crap off the floor i think( the mrs knocked the pellets i pushed through the barrel onto the floor by accident) Other people post vids on youtube and thier pellets fly dead straight out to 100yards why shouldnt mine? anyway i got the protector off heres...

I will try to take the crown protector off later, does it just unscrew if i heat it? i tried to increase the velocity earlier today but it seems tightening the hammer reduces the velocity if anything i seem to find most power was with the screw in about half waybut even then the max i could get...

i shoot with one eye only, ive uploaded a scope cam video its unedited so theres a lot of nothing but ive added a comment showing when pellets are fired you can just click and see them, going to wind the power up a bit and see if that makes any difference this afternoon 0:59 1:25 1:53 2:20 3:14...

Thanks for the replies, im pretty sure the rifle has done it all along, there is no difference with or without the mag the same applies to the air stripper, ive tried jsb 25 grain, h&n barracuda, jsb heavy, fx smooth twist and h&n grizzly all have the same spiral effect some worse than others...

ive cleaned twice with pull through patches but just now i used a brass brush.

Ive got a spiralling pellet issue with my .25 fx 500 at 50 yards it groups nicely but beyond that pellets start to spiral wildly, ive tried a few different types of pellets, cleaned the barrel, checked the crown for burs using a qtip, checked the transfer port the same way and couldnt find...