BanjomanMI76's latest activity

Not done tinkering with it yet after installing the plenum extensions but dialed it in after a regulator adjustment and did some pest...

LOL. Reading this thread I note that not one reply directly addresses the content of your original post, "I have narrowed done my likes...

New Seneca Dragonfly MK 2 .22 cal. MSP Full Review I received my Dragonfly MK 2 the first week of June, 2022. I did a preliminary look...

This will be a bit of a summary of the last year. The long version is here...

I have one because I had to have one of everything and like it but to be honest my HW50 is a whole lot better. Lighter, better trigger...

I put an old Clearidge 3-9x32AO with thin crosshairs to check accuracy. It's a tack driver at 15 yards with meisterkugeln pellets. The...

I found a FWB 124 Sport with Beeman 66R 2-7x32 scope, and universal muzzle brake at a local gunshop. Unfortunately, after a few test...

Here's the 11th edition values, this may or may not help you with your negotiation, but here it is none the less.

Easy to cock, now imagine my 121 at sub 6fpe! :)

Nice looking 50!!!!! . Personally, I use the Slightly Softer Kit from ARH in mine. A little less power but an easier cocking stroke...

Probably stain or dye to bring out the stripes and any figure I think I see something in it based on some of the pictures. I haven't...

"I just bought an ARH JM DIY Turkish walnut stock for mine. Should look awesome hand checkered and finished" KWK, here is my ARH Turk...

According to the serial number list, your FWB standard was made about 08/1982. Can you remember when you bought it? 

It also says Obendorf on the barrel hinge. I did snap some photos, I'll see if I can upload them here.

I bought this FWB 124D in 1979, rebuilt in 2016 with seals, spring, and barrel aligned. I would not sell it for anything, but with...